permabond 105 20g

Permabond 105 Cyanoacrylate Adhesive

Permabond 105 is a low viscosity high purity cyanoacrylate adhesive. It is ideal for use on hard-to-bond plastics and rubbers such as natural rubber, EPDM and butyl rubber.

Permabond 105 Cyanoacrylate Adhesive

Permabond 105 single component cyanoacrylate adhesive ideal for use on hard-to-bond plastics and rubbers that polymerise rapidly when pressed into a thin film between parts.

The moisture adsorbed on the surface initiates the curing of the adhesive. Strong bonds are developed extremely fast and on a great variety of materials. These properties make

Permabond 105 ideal for high speed production lines.

Permabond 105 Applications

  • For use on hard-to-bond plastics and rubbers such as natural rubber, EPDM and butyl rubber.

Features

  • Natural and synthetic rubber bonding
  • Ideal for hard to bond plastics
  • Ease of use –no mixing or heat cure
  • Bonds most materials
  • 100% reactive, no solvents
  • Approved to MIL-A-46050C Type II Class 1 (existing designs)

For pack sizes, please see Additional Information.

Hot Strength

Permabond 105 can withstand higher temperatures for brief periods (such as for paint baking and wave soldering processes) providing the joint is not unduly stressed. The minimum temperature the cured adhesive can be exposed to is -55°C (-65°F) depending on the materials be ing bonded.

Surface Preparation

  • Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces.
  • Some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.

Directions for Use

  1. Apply the adhesive sparingly to one surface.
  2. Bring the components together quickly and correctly aligned.
  3. Apply sufficient pressure to ensure the adhesive spreads into a thin film.
  4. Do not disturb or re-align until sufficient strength is achieved, normally in a few seconds.
  5. Any surplus adhesive can be removed with Permabond CA solvent, nitromethane or acetone.

NB: For difficult or porous surfaces using a Permabond activator is recommended. If bonding polypropylene, polyethylene, PTFE or silicone, prime first with Permabond Polyolefin Primer (POP).

How to use cyanoacrylate adhesives

This product is part of the Permabond range

Want More Information?

Contact a technical specialist for support, information and quotes.

TDS / MSDS

To request any type of technical sheet or safety sheet.

Request a Quote

Please send us your request to receive a customised offer, either for specific products or special requirements.

TECHNICAL DATA SHEET AND SAFETY DATA SHEET

Please fill in the form to receive the .pdf document. 

Filling of gaps and trailing edges
Bonding of sensors and current conductors
Repair, fixing of inserts and added elementsof inserts and added elements
Casing repair and bonding
Tooling with high temperature resistance
Union of added elements: Vortex, Serrations, etc.
Bonding of Nacelle
Control Shaft & Components
Protection of Screws & Components for Export
Sealing of Assembled Parts