Search
Close this search box.
Permabond TA4605 and TA4610

Permabond ET5393 Two-Part Epoxy Adhesive

Permabond ET5393 is a two-part, fully toughened epoxy adhesive. It is ideal for structural applications exposed impact and vibration stresses, and different materials where differential thermal expansion is anticipated.

Permabond ET5393 Two-Part Epoxy Adhesive

Permabond ET5393 is a 1:1 mixable epoxy adhesive. It is fully toughened and ideal for structural applications exposed impact and vibration stresses. It is ideal for bonding different materials where differential thermal expansion is anticipated. ET5393 can be used to bond a wide variety of materials including plastics, composites and metals – in particular, stainless steel. Unlike many other epoxies, ET5393 is less affected by low temperatures during cure and exhibits a reliable cure in colder conditions.

Applications

  • Ideal for bonding plastics, composites and metals – in particular, stainless steel.

Features

  • Adhesion to a wide variety of substrates
  • Full cure at room temperature
  • Steady cure at low temperatures
  • Easy to apply
  • Fully toughened
  • Good impact strength

Surface Preparation

  • Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces.
  • Some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.

Directions for Use

  1. Dual cartridges:
    a) Insert the cartridge into the application gun and guide the plunger into the cartridge.
    b) Remove the cartridge cap and dispense material until both sides are flowing.
    c) Attach the static mixer to the end of the cartridge and begin dispensing the material.
  2. Apply material to one of the substrates.
  3. Join the parts. Parts must be joined within 15-25 minutes of mixing the two epoxy components.
  4. Large quantities and/or higher temperature will decrease the usable life or pot life.
  5. Apply pressure to the assembly by clamping for 3 hours or until handling strength is obtained.
  6. Full cure will be obtained after 24 hours at 23°C (77°F). Heat can be used to accelerate the curing process.

This product is part of the Permabond range.

Category Tags , , Brands: .

Want More Information?

Contact a technical specialist for support, information and quotes.

TDS / MSDS

To request any type of technical sheet or safety sheet.

Get in touch with Antala

The personal data voluntarily provided by you, through this web form will be treated by ANTALA LTD. as responsible for the treatment, in order to meet your request, query, complaint or suggestion, without communications or data transfers occurring and kept for the time necessary to meet your request. You can exercise the rights of access, rectification or deletion of your data, by writing to arco@antala.uk, for more information, you can consult our Privacy Policy

Request a Quote

Please send us your request to receive a customised offer, either for specific products or special requirements.

TECHNICAL DATA SHEET AND SAFETY DATA SHEET

Please fill in the form to receive the .pdf document.